Professional installation techniques for resins (roller)

Professional installation begins with controlling environmental conditions : the temperature and humidity of the air and substrate must fall within the manufacturer's recommended values. Too low temperatures slow down polymerization, while excessively hot or ventilated environments risk excessively accelerating drying, potentially resulting in film defects.

Two-component products must be mixed precisely , respecting the indicated weights or volumes. Incorrect ratios compromise the hardness, adhesion, and chemical resistance of the coating. After mixing, it is necessary to respect the induction times, where applicable, and work within the material's pot life, without "stretching" it once it has already begun to harden.

Roller application is done in multiple coats , with well-defined coverage. The first coat is applied evenly, following a crisscross pattern (first in one direction, then the other), avoiding buildup and puddles. The roller chosen—short, medium, or specifically for resins—affects the final appearance: proper rolling reduces brush strokes and helps achieve a smooth surface.

It's important to respect the recoatability times between coats: applying the next coat too early can trap solvents or water, while too late can reduce intercoat adhesion, especially in products that form very compact films. In some cases, if certain time windows are exceeded, light sanding or thorough cleaning is necessary before proceeding.

When using a roller resin for a non-slip finish , the technique varies: sometimes quartz is dusted onto the fresh coat and sealed with a subsequent layer; other times, a finish with micro-grits is directly applied. In both cases, the distribution must be uniform, to avoid smooth areas next to excessively rough areas.

Particular attention should be paid to edge areas : joints, wall edges, entrances, and connections to different floors. For example, near doors and shutters, it's helpful to carefully study the cycle's detachment point to prevent wheels and tracks from working right on the edge of the resin film, which could cause it to peel off.

A well-finished installation is recognized by its uniform appearance : no shiny puddles or sparse areas, no flaking where untreated cracks exist, and no pronounced "orange peel" effect where not intended. The resin becomes a seamless surface, technically effective and visible like a real coating, not like a makeshift paint.